Check Point Log Exporter parser

The Check Point Log Exporter parser can parse Check Point log messages. These messages do not completely comply with the syslog RFCs, making them difficult to parse. The checkpoint-parser() of AxoSyslog solves this problem, and can separate these log messages to name-value pairs. For details on using value-pairs in AxoSyslog see Structuring macros, metadata, and other value-pairs. The parser can parse messages in the following formats:

   <PRI><VERSION> <YYYY-MM-DD> <HH-MM-SS> <PROGRAM> <PID> <MSGID> - [key1:value1; key2:value2; ... ]

For example:

   <134>1 2018-03-21 17:25:25 MDS-72 CheckPoint 13752 - [action:"Update"; flags:"150784"; ifdir:"inbound"; logid:"160571424"; loguid:"{0x5ab27965,0x0,0x5b20a8c0,0x7d5707b6}";]

Splunk format:


If you find a message that the checkpoint-parser() cannot properly parse, contact us, so we can improve the parser.

By default, the Check Point-specific fields are extracted into name-value pairs prefixed with .checkpoint. For example, the action in the previous message becomes ${.checkpoint.action}. You can change the prefix using the prefix option of the parser.


   @version: 4.0
    @include "scl.conf"
    log {
        source { network(flags(no-parse)); };
        parser { checkpoint-parser(); };
        destination { ... };

Note that the parser expects that the entire incorrectly formatted syslog message (starting with its <PRI> value) is in $MSG, which you can achieve by using flags(no-parse) on the input driver.

The checkpoint-parser() is actually a reusable configuration snippet configured to parse Check Point messages. For details on using or writing such configuration snippets, see Reusing configuration blocks. You can find the source of this configuration snippet on GitHub.



Description: Insert a prefix before the name part of the parsed name-value pairs to help further processing. For example:

  • To insert the my-parsed-data. prefix, use the prefix(my-parsed-data.) option.

  • To refer to a particular data that has a prefix, use the prefix in the name of the macro, for example, ${}.

  • If you forward the parsed messages using the IETF-syslog protocol, you can insert all the parsed data into the SDATA part of the message using the prefix( option.

Names starting with a dot (for example, .example) are reserved for use by AxoSyslog. If you use such a macro name as the name of a parsed value, it will attempt to replace the original value of the macro (note that only soft macros can be overwritten, see Hard versus soft macros for details). To avoid such problems, use a prefix when naming the parsed values, for example, prefix(my-parsed-data.)

By default, checkpoint-parser() uses the .checkpoint. prefix. To modify it, use the following format:

   parser {
Last modified December 4, 2023: Theme update (6377ea9)